![]() I have a C7 hub and originally added them all w/o S2 as that didn’t work until 2.2.4 came out. If there needs to be some work on this, I MIGHT be able to help. (I see that this might have been based on a device handler that was withdrawn by codahq. IIRC, in SmartThings WebCore I had to run a command to put them in Status mode. But I cannot get it to use the LEDs for status, let alone set them. But the Device Control page has options for setting the LEDs. I just said NEXT without entering anything and it worked. The next screen asked for an ID (presumably on the back of the device in the wall). Which I forget the name of, but it was the low level of security, but un-authenticated. As this is installed in my wall already and I have no desire to complicate things with heavier security on 2 lights out of 40 at my home, I tried to clear all the entries. This, however, brings up a security dialog. I added it in Add Mode and then tapping once on the On side of the paddle. turn it on, they 3 quick taps up and three quick taps down. So to join this network, I followed their instructions to reset it. There doesn't appear to be an exclusion for this device. At the bottom of this is a question about getting the LEDs to work in the basic device control.įirst off, Just a bit of info.
0 Comments
Leave a Reply. |